implant bar
 Step 1
First primopattern LC Gel is used to build up, light cure and ...
|
 Step 2
... finish the single copings over the implant posts.
Attention: the screw channels need to be closed (wax)
|
 Step 3
The bar segments will be built up with primopattern LC Paste.
|
 Step 4
To do so, an equivalent amount of Paste is pre-shaped into bar form with the fingers and placed ...
|
 Step 5
... between the copings. Then the complete modellation is light cured and afterwards the bar is milled.
|
 Step 6
Any corrections or re-enforcements will be done with the Gel.
|
 Step 7
These corrections can be stabilized by pre-polymerising the ...
|
 Step 8
... relevant areas with a handheld lab light.
|
 Step 9
Ready!
|